Tuesday, November 30, 2010

CTF Australia Nov 30, 2010

Our first day visiting farms and one manufacturer was very interesting. We headed out to the Darling Downs area near Darby. The area is about 750,000 ha and for the most part very level with slight slopes. Its been raining here a lot which has affected crops quality. The area has low adoption of direct seeding likely due to prosperous farms and no pressing need to change.

We visited with Russell Taylor a 3 meter (120 inch) CTF farmer. He has been developing his system over 13 years and now farms 3000 acres., growing wheat, sorghum, corn, chickpeas and cotton. He has grey cracking soils and some salinity at 90 cm. Continuous cropping, CTF and no till have helped drive the salinity deeper in the profile. Some of his comments:
  • Develop the system around his combine (header)  and has a 9 m header and equipment to match on a 3:1 ratio
  • His biggest challenge in CTF is harvest. The chaser (grain cart) had to go off the tramline to load until he added extensions. He also could not fill the cart full because of his auger system. In addition going off the tramline caused soil damage. Most of those problems have now been fixed.
  • CTF has improved his soil water storage and infiltration significantly.
  • Tramline repair is a necessary, especially following heavy rains.
  • He has been moving openers to avoid seeding on top of the last crop row.
  • Looking to increase the tire width on his JD SP sprayer
  •  Some benefit he saw as he switched to CTF include operator efficiencies and crop benefits by the second year
  • Tim Neale noted that compaction could cause yield issues for up to five years after first occurring.
  • Russell had some good examples of front wheel assist axle extensions.






We also took a look at Wade Bidstrup's 4 m system. He uses a Cat Challenger. They were banding urea on cotton. Four meter systems are fairly rare.


Our third farm stop was at Rod Taylor, one of the first 3 m CTF farmers in Australia and a board member of GRDC. He had deep heavy clay soils. His header width drove his adoption process. As with Russell stored soil water is critical for the success of their winter crops so CTF and no till have helped. Rob could not make no till work in his clay soils until he went to CTF.

He suggested that we don't need to buy all new equipment but can work to adapt current equipment and develop the system as we are able.


We were treated to lunch at the Warra Hall and about 20 or so farmers attended the lunch. I spoke briefly on Alberta agriculture stuff and Jay spoke on surface rights. Coal bed methane is a hot topic in the area.

We finished the day with a tour of the Simplicity plant. They are a leading manufacturer of air tanks and seeding tools. All of their equipment is designed for 2 or 3 meter CTF.  They have a very simple system to allow moving/sliding openers on their tool bar- X Bar system. They design some good equipment and believe in simplicity while still being innovative.



Tomorrow we are visiting 4 farmers and Daybreak engineering.

2 comments:

  1. why is there no crop residue to be seen in the fields?

    ReplyDelete
  2. I think it is realated to a couple of things. Long term drought, wide row spacing and rapid decomposition due to high temperatures and of course no snow. One of Tim's goals is to help farmers get more residue cover. The winter cropping season is usually dry so stored moisture is critical. Summer rains are critical.

    ReplyDelete